The tombstone I made to project onto for 2018 ended up being too small.
I got some white foam from the cold room supplier near my work, so set about making something better for 2019.
The rough front and rear was due to the metal cladding being peeled off.
I cut the foam to a simple shape using a hand saw.
It’s wide to accept the Hi-Rez Designs “Tombstone Trickery” projection.
A base coat of light grey acrylic paint was applied.
This will help seal the surface a little.
The cracks were air brushed on as a bit of an experiment.
Some green was dry brushed on to parts of the right side.
To be continued …